| Table of Contents | ||||
|---|---|---|---|---|
|
Notes
For the Realtime Controller to be able to connect to the robot controller, it must be fully powered on and in REPEAT mode.
...
Required Options
| Note |
|---|
Kawasaki controllers must have the |
Physical Configuration
Network Configuration
The network setting should be configured properly. To do this, press the “MENU” button on the teach pendant, then select “Aux Function” -> “System” -> “Network Setting” -> “Ethernet Port Setting”.
...
Once the network configuration has been completed, RTR suggests using the Realtime Controller to ping the robot, to make sure that the two devices can communicate successfully.
Digital Input / Digital Output Settings
Realtime Controllers also communicate with Kawasaki Controllers using the DI/DO signals.
To do so, follow these steps :
Press “R” on the Teach Pendant, until the home screen appears .
Press “R” again and a screen to enter code should appear.
Enter “611” for the code
“Number of I/O Signals” Page should appear
Enter the values for each field as shown in the image below:
Save / Restart the robot if prompted.
Realtime Controller Configuration
Kawasaki UID
If multiple Kawasaki robots are used, provide a unique UID for each robot.
...